NEWS

NEWS

Home page

10

2022-01

Various types of water pump knowledge and the meaning and function of water pumps

The impeller of the pump body and the motor driving the impeller are submerged into the water to work. There are two kinds of pumps for deep wells and working surfaces. The submersible electric pump for deep well supplies power to the motor through the cable extending into the well, eliminating the need for a long drive shaft, so it is compact in structure, light in weight, easy to install, use and transfer, and has a tendency to replace the long shaft deep well pump in areas with power supply, but It is not suitable for wells with high sand content and areas without power supply. The motors used in submersible pumps are dry type (the motor is completely sealed), semi-dry type (the stator of the motor is sealed, and the rotor runs in water), oil-filled type (the motor is filled with oil to prevent moisture from entering the winding) and wet type (the inside of the motor water-filled, both the stator and the rotor operate in water) and other types. The first three types all need to be sealed and require high manufacturing and installation accuracy. Therefore, the agricultural deep well submersible electric pump usually adopts a wet motor, and its stator winding uses water-resistant insulated wires or pours synthetic resin at the end of the stator winding and in the slot. Small, the sealing structure can be greatly simplified, only sand control is required. Some deep well submersible electric pumps have a lift of up to 1400 meters and a maximum flow of 1.4 m3/s.

2022-01-10

Various types of water pump knowledge and the meaning and function of water pumps

12

2021-11

Development Trend and Type Selection and Maintenance of Water Supply Equipment

With the continuous improvement of water pump design and manufacturing technology and application technology, the manufacture and production of water pumps are developing in the direction of large-scale, large-capacity, high-lift, high-speed, serialization, generalization, and standardization. The level of automatic control of pumping stations is getting higher and higher.

2021-11-12

Development Trend and Type Selection and Maintenance of Water Supply Equipment

12

2021-11

Precautions for use of submersible sewage pump

There are two types of submersible sewage pumps: fixed and mobile. When the fixed automatic installation is adopted, the chain cable should be inserted into the pump outlet separately, and its connection line should be parallel to the pump outlet, and the pump should be lifted up and down in two eyebolts or lifting plates. Slide down the rails evenly and slowly until the automatic coupling is in place. When using a mobile installation, the hose should be put on first, and the electric pump should be lifted up and down through the two rings with a chain rope. Be careful not to use the cable as a rope to avoid danger.

2021-11-12

Precautions for use of submersible sewage pump

12

2021-11

Progressive cavity pumps are also effective in harsh environments

The role of the screw pump in the industrial field is very important. It can be used in harsh environments such as flammable and explosive, and can complete many tasks that are difficult for humans to do manually, ensuring the safety of the staff and reducing economic losses.

2021-11-12

Progressive cavity pumps are also effective in harsh environments

09

2021-11

Which is better, pneumatic diaphragm pump or magnetic pump?

Due to the use of air as power, the flow rate is automatically adjusted with the change of back pressure (outlet resistance), which is suitable for medium and high viscosity fluids. The operating point of the centrifugal pump is set based on water. If it is used for a fluid with a slightly higher viscosity, it needs to be equipped with a reducer or a frequency conversion speed controller, which greatly increases the cost. The same is true for the gear pump.

2021-11-09

Which is better, pneumatic diaphragm pump or magnetic pump?

09

2021-11

Composition and selection principles of the six major structural components of the magnetic pump

The magnetic drive pump (referred to as the magnetic drive pump) is the same as the canned pump that belongs to the pump without shaft seal structure. It has only static seal but no dynamic seal in structure, and it can guarantee that there is no leakage when it is used to transport liquid.

2021-11-09

Composition and selection principles of the six major structural components of the magnetic pump

< 1 2 >

Business License

Contact Information

Manager Chang 13951794560 (same number on WeChat) Email: fuming.chang@beitepump.com

Manager Zhang 13585156185 (same number on WeChat) Email: 286284599@qq.com

Company phone: 025-57155552

Company Address: No. 11, Kangzheng Road, Longchi Street, Liuhe District, Nanjing

Business License

Copyright © Nanjing Better Pump Co., Ltd. | SEO

Power by 300.cn